??? Connection Failed listing tags

older or bad file inserting 52

HydraLIST input for pipe type is reported as "FITTING" and not the letter of the requested pipe type. See the "Error Circles" on drawing at the fitting where the listing instruction expects to have couplings cut in. (such as Grooved Elbow or Grooved Tee) 1 Typical Error Circle Message: Coupling expected but not found for a '????????'. Insert coupling or change fabrication method 2 Typical Error Circle Message: Takeout of fitting does not match takeout expected for a '????????'. Change fitting or fabrication method

Pretty Pipes requires line type TRACKS. This line type is missing from the drawing. Unhandled Except. v50

1) Inserting 3d fittings is very slow & you must hit enter several times to get through the command. Must pick Enter or OK for each fitting. 2) Could also be related to an AutoCAD drawing variable setting.

Screen shows calcing Pump, then getting error 53. Pump calc not calcing Run time 53

Unhandled Exception has occurred in a component in your application

Index was out of range. Must be non-negative and less than the size of the collection.

AutoCAD entities too far out in space for revit to handle

Possibly a rogue lisp routine causing ours not to work HydraCAD v50.any

3dends folder or files missing unhandled exception

Interestingly PDMODE is set to 1. This means that there is no node point at the insertion of these sizes, so the sizes are not found.

All pipe is in the branch line (SPRKDATB) layer solid pipes 3d modeling

Setting incorrect

1. dry pendent sprinkler is defined in the drawing and cannot be generated as Revit content Retrieve content Revit revit Link 4-2

Unknown, but likely that creation of Revit content will still be accomplished.

Runtime error 71

Runtime error 52

When starting AutoCalc, the following error message appears: You have more than ONE Water Supply for these calculations... You have more then ONE Water Supply for these calculations... multiple source point

Method not found: Void HCAD_HUI_CALC.Calc_SystemMatchFitting.set_XrefPipe2Handle(System String)

Error matching operating head @ (xxxx.xxx, yyyy.yyy) The only option is the OK button. ALSO - The equivalent k-factor for node xxx is not an end point.

Unhandled exception: ekey not found